Explanation G Code (Part3)

G248                      : AIC Corner Control ON
G249                      : AIC Corner Control OFF
G254~259             : Work Coordinate System 20~25
G280                      : Travel until contact detection is activated with the AWT Pipe
G328                      : Return to third sub-reference point
G329                      : Set third sub-reference point
G348                      : Outer corner edge path control ON
G349                      : Outer corner edge path control OFF
G354~359             : Work Coordinate System 30~35
G380                      : Travel until contact detection is activated
G428                      : Return to fourth sub-reference point
G429                      : Set fourth sub-reference point
G448                      : Outer corner radius speed control ON
G449                      : Outer corner radius speed control OFF
G454~459             : Work Coordinate System 40~45
G528                      : Return to fifth sub-reference point
G529                      : Set fifth sub-reference point
G548                      : Inner corner radius speed control ON
G549                      : Inner corner radius speed control OFF
G554~559             : Work Coordinate System 50~55
G628                      : Return to sixth sub-reference point
G629                      : Set sixth sub-reference point
G648                      : Inner corner edge speed control ON
G649                      : Inner corner edge speed control OFF
G654~659             : Work Coordinate System 60~65
G728                      : Return to seventh sub-reference point
G729                      : Set seventh sub-reference point
G748                      : Outer corner edge speed control ON
G749                      : Outer corner edge speed control OFF
G754~759             : Work Coordinate System 70~75
G828                      : Return to eighth sub-reference point
G829                      : Set eighth sub-reference point
G854~859             : Work Coordinate System 80~85
G928                      : Return to ninth sub-reference point
G929                      : Set ninth sub-reference point
G954~958             : Work Coordinate System 90~95
G959                      : Machine coordinate System

Comments

Post a Comment

Popular posts from this blog

T Codes

T80     =  Wire Run T81     =  Wire Run Stop T82     =  Auto Drain OF T83     =  Auto Drain ON T84     =  Pump ON T85     =  Pump OFF T86     =  Flushing ON T87     =  Flushing OFF T88     =  Oil Submerged Machining T89     =  Water Flushing Machining T94     =  Water Submerged Machining T90     =  AWT I (wire cutting) T91     =  AWTII (Wire Thread) T96     =  Fluid Feed ON T97     = Fluid Feed OF
Read more

Explanation G Code (Part2)

G104                       : Corner Dwell ON G105                       : Corner Dwell OFF G113                       : Machining slit wire threading OFF G114                       : Machining slit wire threading ON G122                       : Set software positive (+) limit G123                       : Set software negative (-) limit G126    ...
Read more

Explanation G Code (Part 1)

G00    = Positioning G01    = Linear Interpolation G02    = Circular Interpolation CW G03    = Circular Interpolation  CCW G04    = Dwell G05    = X Mirror image G06    = Y Mirror image G07    = Z Mirror image G08    = X Y Exchange G09    = All Mirror  image cancel G11    = Block Skip ON G12    =  Block Skip OFF G13    = Wire breakeage recovery function ON G14    = Wire breakeage recovery function OFF G15    = Wire breakeage recovery function ON (dischrge off,low pressure flushing) G17    = XY plane selection G22    = Software limit ON G23    = Software limit OFF G26    = Figure rotation ON G27    = Figure limit OFF G28    = Return to main reference point G29 ...
Read more