Explanation G Code (Part2)

G104                      : Corner Dwell ON
G105                      : Corner Dwell OFF
G113                      : Machining slit wire threading OFF
G114                      : Machining slit wire threading ON
G122                      : Set software positive (+) limit
G123                      : Set software negative (-) limit
G126                      : Coordinate rotation ON
G127                      : Coordinate rotation OF
G128                      : Return to first reference point
G129                      : Set first sub-reference point
G132                      : Interference avoidance ON
G133                      : Interference avoidance cancel
G134                      : Taper interference avoidance ON
G135                      : Taper interference avoidance cancel
G136                      : Interference error ON
G137                      : Interference error cancel
G140                      : Complex shape cancel
G141                      : Complex shape offset to the left
G142                      : complex shape offset to the right
G148                      : AIC corner control ON
G149                      : AIC corner control OFF
G152                      : Local coordinate system
G153                      : Move to the stroke end
G154~159             : Work coordinate system 10~15
G183                      : Read setting information into specified offset term
G228                      : Return to second sub-reference point
G229                      : Set second sub-reference point

Comments

  1. smithMay 15, 2012 at 7:10 AM

    Organized content is the best way to display or post an article, thank you for making it easy to digest your post.

    Wire cut edm

    ReplyDelete

Post a Comment

Popular posts from this blog

T Codes

T80     =  Wire Run T81     =  Wire Run Stop T82     =  Auto Drain OF T83     =  Auto Drain ON T84     =  Pump ON T85     =  Pump OFF T86     =  Flushing ON T87     =  Flushing OFF T88     =  Oil Submerged Machining T89     =  Water Flushing Machining T94     =  Water Submerged Machining T90     =  AWT I (wire cutting) T91     =  AWTII (Wire Thread) T96     =  Fluid Feed ON T97     = Fluid Feed OF
Read more

Explanation G Code (Part 1)

G00    = Positioning G01    = Linear Interpolation G02    = Circular Interpolation CW G03    = Circular Interpolation  CCW G04    = Dwell G05    = X Mirror image G06    = Y Mirror image G07    = Z Mirror image G08    = X Y Exchange G09    = All Mirror  image cancel G11    = Block Skip ON G12    =  Block Skip OFF G13    = Wire breakeage recovery function ON G14    = Wire breakeage recovery function OFF G15    = Wire breakeage recovery function ON (dischrge off,low pressure flushing) G17    = XY plane selection G22    = Software limit ON G23    = Software limit OFF G26    = Figure rotation ON G27    = Figure limit OFF G28    = Return to main reference point G29 ...
Read more